Hey all,
well it is now all over and done with (big sigh of relief)! Just to finish off i thought I'd leave you with my thought on the review...
Overall, i think it went really well...our group seemed to have addressed all the problems to a high standard.
We received positive feedback about our design, and its presentation. We did receive some suggested improvements still. These included a better way of presentation our circulation patters etc, through a section rather than a plan, as well as small things like "finishing off" the concept. The reviewers all agreed that our domus was interesting and exciting to move through...and then you end where you do...in a rather basic room. I had no looked so far as to see this anticlimax to a journey but it will most definitely help for future designs.
Thank-you to all of those wonderful people who gave us feedback on our design, and thank you also to Reece and Dan...been a pleasure working with you!
bye for now
Liz
Thursday, May 31, 2007
Copacobana C6 - Model Images
Here are some shots of the model we created.
Each panel on the facade was created using AutoCAD. These were then loaded into the lazer cutter machine, and cut out using a lazerbeam.
We decided to leave the panels in their raw state, having the dark edge from the lazer in combination with the colour gradient from the heat across the panels.
The site gradient (hill) was also created using the same system, however being spray-painted to add a contrast between the hill and the model itself.
Hope you like the outcome!
Each panel on the facade was created using AutoCAD. These were then loaded into the lazer cutter machine, and cut out using a lazerbeam.
We decided to leave the panels in their raw state, having the dark edge from the lazer in combination with the colour gradient from the heat across the panels.
The site gradient (hill) was also created using the same system, however being spray-painted to add a contrast between the hill and the model itself.
Hope you like the outcome!
domus model_dan webster (copocobana 6)
Here is the model the reece, liz and myself built.
The site is made of 9mm mdf board with a gradient.The main model is also made of mdf, but it is 3mm. Each piece was made constructed in autoCAD and then we used the laser cutter to cut the parts out.
Copacobana C6 - Additional Poster Diagrams
Here are some images of diagrams that weren't shown on our posters above.
Wednesday, May 30, 2007
(Copacobana C6) Domus- Buildings' areas
Eaves protection against the hot north sun (study area and communal room)
Interior perspective of communal room (rusty colour wall is the thermal mass wall)
Interior view of sleeping pods with shelving above
Bathroom, toilet, shower, and laundry area
Interior perspective of communal room (rusty colour wall is the thermal mass wall)
Interior view of sleeping pods with shelving above
Bathroom, toilet, shower, and laundry area
Subscribe to:
Posts (Atom)